basic power industries
177 Fulford Dr.
Harkers Island, NC 28531
(252) 504-3355

Tools Testing Equipment


Grid View ActiveView as Grid

CDI511-9772


Adapter DC Ampmeter Tool Outboard Motor DVA Testing CDI511-9772

Adapter DC Ampmeter Tool Outboard Motor DVA Testing CDI511-9772

511-9772 Ampmeter Adapter Replaces: PL88 Use to replace ignition coil for testing DVA output from ignition pack if a bad coil is suspected.

$64.95




CDI511-9788B


Adapter Noise Filter Outboard Motor Testing 2 Cycle CDI 511-9788B

Adapter Noise Filter Outboard Motor Testing 2 Cycle CDI 511-9788B

2 cycle noise filter used with Fluke 88 meter with RPM pickup, P/N 518-RMP80, to reduce outboard noise interference for inductive pickup applications.

$68.95




CDI511-9773


Adapter Peak DVA Voltage Test Tool Fluke Meter for Outboard 511-9773

Adapter Peak DVA Voltage Test Tool Fluke Meter for Outboard 511-9773

Peak Reading DVA Voltage Adapter for all Fluke digital volt meters. The readings will be close to the Stevens CD77 and Merc-Otronic specs. Ideal companion with Piercing Probe Set CDI511-9770. (See...

$75.95





CDI551-334M


Adaptor, Metric, Grease Filler

Adaptor, Metric, Grease Filler

Metric Adapter for Grease Filler Replaces 519-34M, 551-33M, 551-34M For all motors except Suzuki.

$11.95  $9.99



Max: 3

CDI554-9706


Amp Pin Removal Tool

Amp Pin Removal Tool

Amp Pin Removal Tool Used to remove the connector pins in the ignition system on Chrysler/Force engines using the Prestolite type ignitions. Also used on Mercury TPI sensor connectors.

$22.95




THWDSW-3-B


Boat Wash Down Station Marine Boat Lid 15 ft White Hose Pistol Grip Nozzle

Boat Wash Down Station Marine Boat Lid 15 ft White Hose Pistol Grip Nozzle

Boat Wash Down Station - White Hose - Pistol Grip Nozzle - Sand Shell Lid Flush Mounted Wash Down Station with Lid Storage Tube with Screw Out CoverIncludes 15 Feet of High Quality Poly Coiled...

$68.95





CDI911-9783


Bullet Connector Kit

Bullet Connector Kit

Bullet Connector Kit Contains: 10 each Male Bullet with Boots, and 10 Female Bullets with Sleeves. Contains 10 pieces each of the male, female connectors and sleeves.

$12.95




THDFMK-1-DP


Double Flusher Twin Outboard Engine Flush Kit

Double Flusher Twin Outboard Engine Flush Kit

The Double Flusher™ twin outboard boat engine flush kit allows you to flush two outboards at the same time and allows you to quickly turn water off and on while you are at the motors. Flush...

$31.95




CDI511-9773NL


DVA Peak Voltage Adapter without leads

DVA Peak Voltage Adapter without leads

Peak Reading DVA Voltage Adapter for all Fluke digital volt meters. This adapter does not include the leads. If you require one with leads, please order CDI511-9773. The readings will be close to the...

$75.95  $60.99



Max: 2

CDI551-33CV


Filler Vent Check Valve

Filler Vent Check Valve

Filler Vent Check Valve Calibrated check valve creates airlock to keep lube from running out while you install drain plug. Includes 4" Hose. A must for all shops! Included with CDI551-33GF.

$20.95




CDI518-88


Fluke 88 Meter Kit with DVA Adapter

Fluke 88 Meter Kit with DVA Adapter

Measures 2 and 4 stroke RPM ranges, volts, ohms, amperage, dwell, and injector pulse width. It has the capability of recording maximum and minimum RPM and volts. Backlight display readout is easy...

$650.95




CDI551-33-1


Gearcase Filler

Gearcase Filler

Gearcase Filler With Check Valve A new design in gearcase fillers makes it easier to fill or flush gearcases. The check valve venting system helps prevent spilling any gear lube. The check valve on...

$159.95





CDI551-334S


Gearcase Metric Adaptor for Suzuki

Gearcase Metric Adaptor for Suzuki

Metric Adapter for Suzuki motors for use with CDI551-33GF E-Z Fill

$10.95  $8.99



Max: 2

CDI991-9705


Grease Dielectric for Sealing Connections, Corrosion and Better Contact

Grease Dielectric for Sealing Connections, Corrosion and Better Contact

Dielectric Grease, 3 oz. tube. Used to help seal connections and inhibit corrosion. Gives better electrical contact and high voltage isulation. Dielectric Grease is used to keep water and corrosion...

$27.95




MAL9-15400


Ignition Safety Switch Lanyard for Universal Outboards Mercury 40970

Ignition Safety Switch Lanyard for Universal Outboards Mercury 40970

Lanyard Switch Ignition Safety Replaces: Mercury MP 40970 Fits: Universal Designed to kill ignition whe thrown fron controls. Where Ignition Is Just The Start.

$21.95





CDI923-3356


Kill Plug, Large

Kill Plug, Large

Large Kill Plug Replaces 513356

$8.95




CDI923-3404


Kill Plug, Small

Kill Plug, Small

Small Kill Plug Replaces 123404

$11.95




CDI511-9775


Load Resistor

Load Resistor

Load Resistor To load the output of ignition modules when testing ignition coils. Used for testing DVA outputs from power packs and switch boxes. Replacement for Stevens PL88.

$18.95





THMSS-1-DP


MOTOR STIK Outboard Motor Support - Pair in Clam Package

MOTOR STIK Outboard Motor Support - Pair in Clam Package

MOTOR STIK™ Outboard Motor Support Pair (for one outboard motor) Fits Over Trim Rams Supports Your Outboard While Trailering Takes the Pressure Off of Hydraulic System Most Outboards 150hp and...

$34.95




CDI511-9800


Multimeter Resistor Test Card

Multimeter Resistor Test Card

Resistor Test Card for Multimeters

$9.95  $8.99



Max: 3

CDI518-116


Multimeter Tool Fluke Meter Volt Meter Ohm Meter CDI 518-116

Multimeter Tool Fluke Meter Volt Meter Ohm Meter CDI 518-116

Replaces discontinued CDI518-16 (series) meters AutoVolt: automatic AC/DC voltage selection Large white LED backlight to work in poorly lit areas Resistance and continuity Min/Max/Average to record...

$299.95





SMI01117


Oil - Fuel Filter Wrench

Oil - Fuel Filter Wrench

This handy wrench removes screw on type marine water separator fuel filters and most oil filters Tough, forged stainless steel

$22.95




CDI553-2698


Pin Removal Tool

Pin Removal Tool

Pin Removal Tool Replaces 322698

$27.95




CDI551-34PV


Pressure Vacuum Tester Tool Outboard and Outdrives CDI 551-34PV

Pressure Vacuum Tester Tool Outboard and Outdrives CDI 551-34PV

Pressure and Vacuum Tester Repairable metal unit does both vacuum and pressure testing. Screws into the fill on most applications and introduces your choice of vacuum or pressure to test units for...

$219.95





SIE18-9781


Pump Oil for Lower Unit Fits Quart Bottles

Pump Oil for Lower Unit Fits Quart Bottles

Oil Pump for Quart bottle, 4 cc pump and 3/8" - 16 swivel metal marine filler fitting. Ideal for adding Gear Lube and other fluids to small engines and marine lower units. Flexible Hose for...

$15.95




THQF-1K-DP


Quick Flush Outboard Engine Flush Kit Complete Kit Johnson Evinrude

Quick Flush Outboard Engine Flush Kit Complete Kit Johnson Evinrude

Quick Flush™ Outboard Flush Fitting Complete Kit for Johnson/Evinrude T-H Marine introduces a quick and easy way to flush any outboard equipped with a flushing port. No more removing the plug...

$16.95




THQF-2K-DP


Quick Flush Outboard Engine Flush Kit Complete Kit Mercury Yamaha

Quick Flush Outboard Engine Flush Kit Complete Kit Mercury Yamaha

Quick Flush™ Outboard Flush Fitting Complete Kit for Mercury, Yamaha and other outboards T-H Marine introduces a quick and easy way to flush any outboard equipped with a flushing port. No more...

$16.95





THQFC-1-DP


Quick Flush Outboard Engine Flush Kit Connector for Hose Fits All Slide Valves

Quick Flush Outboard Engine Flush Kit Connector for Hose Fits All Slide Valves

Quick Flush™ Outboard Flush Fitting Connector for Hose (connects to garden hose) T-H Marine introduces a quick and easy way to flush any outboard equipped with a flushing port. No more removing...

$5.95




THQFV-1-DP


Quick Flush Outboard Engine Flush Kit Slide Valve Only Johnson Evinrude

Quick Flush Outboard Engine Flush Kit Slide Valve Only Johnson Evinrude

Quick Flush™ Outboard Flush Fitting Slide Valve (installs on Johnson/Evinrude outboard motors) T-H Marine introduces a quick and easy way to flush any outboard equipped with a flushing port. No...

$12.95




THQFV-2-DP


Quick Flush Outboard Engine Flush Kit Slide Valve Only Mercury Yamaha

Quick Flush Outboard Engine Flush Kit Slide Valve Only Mercury Yamaha

Quick Flush™ Outboard Flush Fitting Slide Valve (installs on Mercury, Yamaha and other outboard motors) T-H Marine introduces a quick and easy way to flush any outboard equipped with a flushing...

$12.95





CDI553-9702


Sensor Gap Gage, Johnson, Evinrude

Sensor Gap Gage, Johnson, Evinrude

Sensor Gap Tool, Use to reset the air-gap on Johnson/Evinrude sensor to flywheel clearance (Power Pack 3,4)

$10.95




CDI553-2699


Socket Removal Tool

Socket Removal Tool

Socket Removal Tool Replaces 322699

$27.95




CDI511-9766


Spark Gap Tester Tool Adjustable 1 to 8 Cylinder 511-9766

Spark Gap Tester Tool Adjustable 1 to 8 Cylinder 511-9766

511-9766 Spark Tester Spark tester can be used to test from 1 to 8 cylinders. Sealed design reduces the possibility of fire. NOTE: If extension wires are needed, order P/N: 511-9903 (set of 4 wires)....

$62.95







ebasicpower.com is © 1999- Basic Power Industries, Inc., all rights reserved • All Item specifications and availability are subject to change without notice
Basic Power Industries • 177 Fulford Dr, Harkers Island, NC 28531-9520, US • +1-252-504-3355